Table of Contents
Advertisement
User Manual – Sound generation parameters
4.2 COMPRESSOR SECTION
Compressor effect parameters.
COMPRESSOR ON/OFF
Range: Off, On
NRPN MSB=1, NRPN LSB=0
Data Entry MSB Range: 0, 1
Enables/disables the Compressor effect.
THRESSHOLD
Range: -36...0 dB
NRPN MSB=1, NRPN LSB=1
Data Entry MSB Range: 0...127
Sets the signal level, also called theshold, by dB; the
compressor only works above the Threshold.
RATIO
Range: 1,2:1...10:1
NRPN MSB=1, NRPN LSB=2
Data Entry MSB Range: 0...9
Sets the quantity of compression of the dynamic
range of the signal. It works based on a direct
proportion. For example, if the compression rate is
1:1
there is no compression at all;
compression rate of 3:1 the signal is three times
more compact than the original.
Output
Thres.
Level
ATTACK
Range: 0,50...200 msec.
NRPN MSB=1, NRPN LSB=3
Data Entry MSB Range: 0...127
Sets the time (in millisecond) it takes for the effect to
start lowering the signal, when it goes beyond the
threshold. The higher the value, the longer it takes
before the effect lowers the signal.
RELEASE
Range: 50...500 msec.
NRPN MSB=1, NRPN LSB=4
Data Entry MSB Range: 0...127
Sets the time (in milliseconds) it takes for the effect
to stop reducing the level, after the signal has
returned below the threshold.
Signal
Level
Input Signal
Output Signal
Attack
with a
Ratio
1,2:1
3:1
10:1
Input
Level
Thres.
Time
Rel.
EN - 14
4.3 AMPLIFIER SECTION
Amplifier effect parameters.
AMPLIFIER ON/OFF
Range: Off, On
NRPN MSB=2, NRPN LSB=0
Data Entry MSB Range: 0, 1
Enables/disables the Amplifier effect.
PRE- AMPLIFIER TYPE
Range:
-
1...10: valve amp
-
11...15: transistor amp
-
16...19: an amp with more performant valves
than the Tube
NRPN MSB=2, NRPN LSB=1
Data Entry MSB Range: 0...18
Select the preamplifier type.
PRE- AMPLIFIER DRIVE
Range: 0...127
NRPN MSB=2, NRPN LSB=2
Data Entry MSB Range: 0...127
Adjusts the pre-amplifier's gain.
HI DAMP
Range: 1k6...4k0
NRPN MSB=2, NRPN LSB=3
Data Entry MSB Range: 0...4
Sets the cutoff frequency of the pre-amplifier's low-
pass filter.
•
POWER AMPLIFIER TYPE
Range:
-
1: a sweet combo, with lighter sounds
-
2: a sharp-edged combo
-
3: an amp with a rich sound
-
4: loud combo with a strong presence and
clean tone
-
5: this amp highlights the middle frequencies
-
6: this amp highlights mid-low frequencies
NRPN MSB=2, NRPN LSB=4
Data Entry MSB Range: 0...4
Select the type of power amplifier.
POWER AMPLIFIER CHARACTER
Range: 0...127
NRPN MSB=2, NRPN LSB=5
Data Entry MSB Range: 0...127
Adjust the amp's character.
CABINET TYPE
Range:
-
1: direct injection box
-
2: one-cone cabinet
-
3: two-cone cabinet
-
4: four-cone cabinet
NRPN MSB=2, NRPN LSB=6
Data Entry MSB Range: 0...4
Sets the cabinet type.
CABINET COLOR
Range: 0...127
NRPN MSB=2, NRPN LSB=7
Data Entry MSB Range: 0...127
Adjust the cabinet timbre.
Advertisement
Table of Contents
