Replacing The Power Supply Assembly - Lenovo ThinkStation C30 Hardware Maintenance Manual

Note: Your microprocessor socket and cover might look slightly different from the illustration.

Replacing the power supply assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
Safety Information" on page 1.
This document provides instructions on how to replace the power supply assembly.
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to ive
minutes to let the computer cool before removing the computer cover.
To replace the power supply assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove any locking device that secures the computer cover, such as a padlock or an integrated
cable lock.
3. Remove the computer cover. See "Removing the computer cover" on page 80.
4. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 81.
5. Remove the PCI card holder. See "Removing and reinstalling the PCI card holder" on page 81.
6. Remove the optical drive. See "Installing or replacing the optical drive" on page 87.
.
Chapter 10 Replacing FRUs
121