6. Open the small handle
a little bit outward to release it from the secured position. Then, open the other small handle
following the same instructions. Ensure that the small handles are in the fully open position.
Note: There are two marks on the microprocessor retainer. You need to open the small handle marked
with
irst and then you can open the other small handle marked with
Figure 39. Opening the handles
7. Gently press down the small handle
until it is in the fully open position.
Figure 40. Opening the microprocessor retainer
by gently pressing down the small handle and then pulling the small handle
2
to open the microprocessor retainer. Pivot the retainer upward
2
by
1
.
.
Chapter 10
Replacing FRUs
109