Advertisement
b) Clean tool and lubricate tool; particularly the head assembly
c) Increase air pressure when working with harder woods;
never exceed 110 psi (7.6 bar)
d) Check the driving blade for broken end
e) Ensure the tool is well seated on the floor while ejecting
(5) T
OOL DOES NOT ACTIVATE
a) Check the air supply
b) Inspect the head assembly and check all seals; reassemble
carefully
(6) D
RIVING BLADE DOES NOT RETURN
a) Check for jammed cleat or obstruction
b) Check gate/foot and end of feeder channel for damages or
burrs.
c) Check the driving blade P-223
d) Inspect the head assembly and check all seals; clean &
lubricate
e) Check for damaged or missing bottom O-ring P-014
f) Tighten reinforcement plate
g) Check that the bumper is in place.
(7)
BROKEN OR WORN DRIVING BLADE
Replace the driving blade P-223. Failure to follow the
instructions carefully will result in repeated breakage of the
driving blade.
(8) P
OOR FEED OR TOOL JAMMING
a) Make sure the feeder clip engages behind the cleats
b) Check the gate and foot for damages or wear
c) Check the front end of the feeder channel for burrs or
damages
(9) O
THER PROBLEMS
Contact Primatech:
by phone
by email
consult our on-line Technical Support site at
ACCESSORIES
P-149
18" (45 cm) "L" feeder channel
P-951
"T" type cleats conversion kit
P-080
Hammer
H-082
Double-head hammer
P-084
White rubber cap
1 (800) 363-1962
1 (418) 522-7744
support@primatech.ca
http://www.primatech.ca/support
P-188
Adapter for 1/2" to 5/8" (13 to 17mm) solid
P-288
Adapter for 3/4" to 33/32" (19 to 26mm)
P-090
Non detergent oil
TrakEdge Adapter plates for factory finished floorings.
A-001
for standard 3/4" floorings
A-004
for 9/16" & 5/8" floorings
Custom fits to flooring manufacturers specifications also
available. Contact us for more information.
A-800 Extension Handle
The A-800 extension handle allows to operate the tool at a
higher or lower position. Il provides a better tool control,
improve ease and stability when sliding the tool sideways.
OTHER PRIMATECH NAILERS
P
offers a full line of professional tools for the installation
RIMATECH
of hardwood flooring:
H300
standard model, manual operation
H330
standard model, 'Multiple-Hits' manual operation
Q500
manual operation, for solid wood 1/2" (1.25 cm) or 3/8"
(1 cm) thick
R610
manual operation, for engineered flooring
PRIMATECH CLEATS
For best results, always use P
2" (50 mm) "L" or "T" type
1¾" (44 mm) "L" type
1½" (38 mm) "L" or "T" type
cleats:
RIMATECH
Advertisement
