primatech Q500 Quick Start Manual

Q500

ODEL

This manual nailer has been developed to work with 3/8" to 5/8" boards. It is a single hit nailer which drives

1¼" (32mm) and 1½" (38mm) 18-

L-type flooring cleats at the perfect location and angle. It comes with

GAGE

a set of plastic bases to precisely fit any solid boards.

For superior performance, use only P

cleats

RIMATECH

Printed in Canada

05/14

Table of Contents

Need help?

Do you have a question about the Q500 and is the answer not in the manual?

George Kliendienst

July 10, 2025

how to load the nails properly

Page 1 Q500 ODEL This manual nailer has been developed to work with 3/8" to 5/8" boards. It is a single hit nailer which drives 1¼" (32mm) and 1½" (38mm) 18- L-type flooring cleats at the perfect location and angle. It comes with GAGE a set of plastic bases to precisely fit any solid boards.
Page 2 2. For the next few rows, drill at 45 angle at the tongue and use finishing nails as shown. 3. Using your Q500 nailer, fix the flooring at the 50 pre- determined angle. Nail at 3" from the ends and at every 6-8".
Page 3 1½" cleats (thicker, 100 per clip). GAGE AINTENANCE The Q500 nailer should require little maintenance. In case the driving blade, spring or blade retainer need to be replaced, follow these instructions: 1) Pull on the ring Q-051B to release the plunger Q-020.
Page 4 SEVEN-YEAR EXTENDED LIMITED WARRANTY covers tool casing. WARRANTY STATEMENT Primatech ‘s sole liability hereunder will be to replace any part or accessory which proves to be defective within the specific time period. Any replacement part or accessories provided in accordance with this warranty will carry a warranty for the remainder of the period of warranty applicable to the part it replaces.