Related Manuals for primatech P240
Summary of Contents for primatech P240
-
Page 1: Operating Instructions
PNEUMATIC FLOORING NAILER P240 OPERATING INSTRUCTIONS WARNING Read these instructions thoroughly before using this tool and keep it handy for reference. Revision 06/05 Printed in Canada... -
Page 2: Safety Measures
TOOL STAYS CHARGED AFTER DISCONNECTING THE AIR SUPPLY HOSE These important guidelines should always be followed to work safely with the P pneumatic nailer model P240: RIMATECH NLOAD TOOL BEFORE CONNECTING AIR TO PREVENT ACCIDENTAL DISCHARGE Read these instructions thoroughly before using this tool and keep it handy for reference if necessary. -
Page 3: Operation
MAXIMUM PERFORMANCE RIMATECH Accidental ejection of nails or wood debris could cleats. The P model P240 comes standard with the P-148 RIMATECH cause severe eye injury. feeder channel to accommodate 1½" (38 mm), 1¾" (44 mm) or 2" (50 mm) L-type cleats. It may be ordered or converted with the In some environments, ear protection might be P-951 kit to accommodate 2"... - Page 4 This tool requires minimal lubrication. Use only the six (6) screws P-015 and take the head assembly off the tool. detergent-free oil such as Primatech P-090. Few drops Remove the valve main screw P-544B with an 3/16" Allen key and of oil weekly in the air inlet is sufficient.
-
Page 5: Troubleshooting
Insert actuator assembly P-542. It should slide smoothly. TROUBLESHOOTING Insert main valve assembly P-543 . This section will help to diagnose problems that might alter the quality of work done by the operator, or the tool, and will give Carefully put actuator cap assembly P-544 in place. suggestions on how to solve them. -
Page 6: Other Primatech Nailers
(8) P OOR FEED OR TOOL JAMMING OTHER PRIMATECH NAILERS a) Make sure the feeder clip engages behind the cleats b) Check the gate and foot for damages or wear c) Check the front end of the feeder channel for burrs or...