Frico Thermozone AD Corinte A/E User Manual page 28

GB
2 That the heat demand exists; check
thermostat settings and actual temperature.
3 That the output selector (if any) is set
correctly.
4 That the overheat protection has not been
deployed, see description above.
Maintenance
To ensure performance and reliability of the
air curtain inspection should be carried out
regularly, at least twice a year, but this can
vary depending on local conditions. This is to
ensure the performance of the air curtain and
heat output of the unit.
The inlet grille works as a filter and should
be vacuumed regularly. A too low airflow
might cause over heating.
Since fan motors and other components are
maintenance free, no maintenance other than
cleaning is necessary. Undertake cleaning at
least twice a year.
A sample of "Fingerprint remover" is inclu-
ded on delivery. The product gives a clean and
dry surface. To order, please state no 11631,
Fingerprint remover (0,5 l).
Residual current circuit breaker
(applies to units with electric heater)
When the installation is protected by means
of a residual current circuit breaker, which
trips when the appliance is connected, this
may be due to moisture in the heating ele-
ment. When an appliance containing a heater
element has not been used for a long period
or stored in a damp environment, moisture
can enter the element.
This should not be seen as a fault, but is
simply rectified by connecting the appliance
to the mains supply via a socket without a
safety cut-out, so that the moisture can be
eliminated from the element. The drying time
can vary from a few hours to a few days. As
a preventive measure, the unit should occa-
sionally be run for a short time when it is not
being used for extended periods of time.
28
Thermozone AD Corinte A/E - ADCS
Safety
• For all installations of electrically heated
products should a residual current circuit
breaker 300 mA for fire protection be used.
• Keep the areas around the air intake and
exhaust grilles free from possible obstruc-
tions!
• During operation the surfaces of the unit
are hot!
• The unit must not be fully or partially co-
vered with clothing, or similar materials,
as overheating can result in a fire risk!
• This appliance is not intended for use by
persons (including children) with reduced
physical or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a per-
son responsible for their safety. Children
should be supervised to ensure that they do
not play with the appliance.