Agri-Fab LST42C-669 Owner's Manual page 23

STEP 45: (SEE FIGURE 44)
• Turn the clutch/idler assembly right side up.
• Slightly loosen the hex bolt next to the flat idler pulley.
Install the drive belt down between the hex bolt and the
flat idler pulley with the flat side of the belt against the
pulley. Retighten the hex bolt.
• Loop the belt around the large v-pulley, placing it
between the v-pulley and the hex bolt next to the pulley.
Place the belt to the inside of the other flat idler pulley.
HEX BOLTS
DRIVE BELT
FIGURE 44
Did you choose the correct drive belt for
STOP
your tractor? Using the wrong length belt
may cause premature bearing or belt failure.
STEP 46: (SEE FIGURE 45)
• Attach the clutch/idler assembly to the tractor frame
as follows. Hook the assembly's notched arms onto
the two shoulder bolts you assembled to the inside
of the tractor frame. Lift the front of the assembly and
attach it to the R.H. and L.H. hanger brackets using
two pivot lock pins (GG) and 1/8" hairpin cotters (EE).
1/8" HAIRPIN COTTER (EE)
FIGURE 45
FLAT IDLER
PULLEY
PIVOT LOCK PIN (GG)
(use second hole)
RIGHT SIDE VIEW
STEP 47: (SEE FIGURE 46)
• Assemble the drive belt onto the engine pulley and
then onto the large pulley on top of the clutch/idler
assembly. The belt must be placed to the inside of
the idler pulley and the keeper bolt located beside the
large pulley.
• Place tension on the belt by pulling the left side
tensioning chain out as far as the 3/32" hairpin cotter
(FF) will allow. Secure the chain in this position by
inserting a 1/8" hairpin cotter (EE) through the chain.
IMPORTANT: Do Not assemble the "V" belt around the
outside of the engine pulley keeper or the keeper bolt.
CLUTCH/IDLER ASSEMBLY
IDLER
PULLEY
FIGURE 46
23
Left Side
of Tractor
ENGINE
ENGINE
PULLEY
PULLEY
1/8" HAIRPIN
COTTER (EE)
KEEPER
BOLT
VIEWED FROM UNDERNEATH