Alde Compact 3020 HE Operating Instructions Manual page 31

Alde Compact 3020 HE Operating Instructions
Temperature Sensor
If any Alde 3010-238 discrete room temperature sensors are connected, this allows you
to select:
• Control panel. Temperature is measured at the control panel.
• Living room. Temperature is measured at discrete room temperature sensor 1.
• Bedroom. Temperature is measured at discrete room temperature sensor 2.
• Auto. Temperature is measured at the control panel, but automatically selects a
discrete room temperature sensor when connected, prioritising sensor 1. This allows
the sensor to be selected with a convenient wall switch.
Load Monitor
If an Alde 3010-246 load monitor is installed, this allows you to set an amp limit from
5–17 A for the vehicle's 230 V power. If the current drawn by the vehicle exceeds the
amp limit, the boiler and Truma Aventa Comfort air-conditioning unit (if connected) will
automatically reduce power.
This helps avoid tripping the circuit breakers on the electric hook up. The load
monitor can be disabled by selecting "Off". NB: AC must be enabled on the control panel
for the Truma Aventa Comfort air-conditioning unit to respond to the load monitor.
EisEx Heating
If a Truma EisEx defroster is installed, this allows you to select:
• Winter. EisEx heating for the gas regulator is on.
• Summer. EisEx heating for the gas regulator is off.
If a Truma DuoControl or DuoControl CS gas regulator is installed, gas cylinder status is
also shown.
Engine Pre-Heat (requires Clock to be set)
If an Alde 2755-000 engine pre-heat pump is installed, allows you to use the central
heating as a block heater. Once enabled, the engine pre-heat pump will circulate fluid
around the engine radiator, via the Alde engine heat exchanger, on the set time and day
for a fixed 60 min cycle. NB: If the central heating is cool, the engine will not be pre-
heated.
31