Replacing The Headlight Bulb - Yamaha XVS1100V Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
7. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
8. Place the ignitor unit panel in the
original position and install the
quick fasteners.
NOTE:
To install a quick fastener, push its pin
back so that it will protrude from the fas-
tener head, then insert the fastener and
push the protruding pin in until it is flush
with the fastener head.
6
1. Quick fastener (after removal)
2. Quick fastener (before installation)
9. Install the rider seat.

Replacing the headlight bulb

This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
1. Remove the headlight unit by re-
moving the screws.
1. Screw
2. Disconnect the headlight coupler,
and then remove the bulb cover.
3. Unhook the headlight bulb holder,
and then remove the defective
bulb.
6-30
EAU23792
1. Headlight bulb holder
WARNING
Headlight bulbs get very hot. There-
fore, keep flammable products away
from a lit headlight bulb, and do not
touch the bulb until it has cooled
down.
4. Place a new headlight bulb into po-
sition, and then secure it with the
bulb holder.
CAUTION:
Do not touch the glass part of the
headlight bulb to keep it free from
oil, otherwise the transparency of
the glass, the luminosity of the bulb,
and the bulb life will be adversely af-
EWA10790
ECA10660