Panasonic WV-SFV481 Operating Manual page 118

11 Configure the settings relating to images and audio [Image/Audio]
On this page you can adjust the 90° tilting angle and vertical angle set when the camera was mounted, as well
as the horizontal position of the cropping position.
When "Image capture mode" is set as follows, the initial position can be set.
Double Panorama/ Panorama/ 8M Fisheye + Double Panorama/ 4M Fisheye + Double Panorama/ 8M Fisheye
+ Panorama/ 4M Fisheye + Panorama
IMPORTANT
•
VMD is deactivated while the initial position setup menu is displayed. Close the initial position setup
menu after completing the settings.
•
If the initial position setting of panorama or double panorama images is changed when the following
areas are configured, the areas must be configured again.
–
Privacy zone (®page 121)
–
VMD area (®page 143)
–
VIQS area (®page 123)
–
Mask area (®page 112)
•
When "Image capture mode" is set to 9M Fisheye or 4M Fisheye, the preset positions (Initial position
setup menu) cannot be set.
Note
•
To making fine adjustments to the initial position setting, refer to the information in the Installation Guide
and rotate the image using the image rotation gear.
For Panorama images
[Position adjust] buttons
•
: Rotates the display position 90° in a counterclockwise direction.
•
: Rotates the display position 90° in a clockwise direction.
118 Operating Instructions