Table of Contents
Advertisement
OPERATION FOR ROOM AIR BLOWER
Your heater is equipped with a room air blower. For operation and wiring see below.
Operation.
After heater has warmed up the thermostat will automatically turn on blower When the stove
cools off, thermostat will automatically shut off blower.
MOTOR
Maintenance.
Unit installed a prefabricated fireplace. To replace motor or thermostat without pulling stove
from fireplace.
1. Open feed access door, clean all ashes and debris from inside fire box .
2. Remove fire brick from floor of inside fire box (some brick may need prying, try not to not
damage the brick) lay brick aside.
3. Remove fire brick from inside back of fire box and lay brick aside.
4. Gently remove the fire blanket from inside back of fire box.
5. Remove plate inside back of fire box and a second fire blanket .
6. Remove a inner back plate by removing (8 eight) blots (NOTE; you may need to spray
WD-40 onto bolts) lay aside.
7. You access blower motor and thermostat through opening inside back of fire box.
8. After replacing parts, reverse the steps 1-7.
BRICK LAYOUT
Unit installed as free standing.
1. At the back of unit there is a rear motor cover, remove the (2 two) screws at the bottom of the
cover, slide down and lay rear motor cover aside.
2. You access blower motor and thermostat through opening in the back of the stove.
3. After replacing parts, reverse the step 1.
SECTION VIII
AND MAINTENANCE
BLACK
WHITE
ACCESS FROM INSIDE
BACK OF STOVE
Page 34
THERMOSTAT
BLACK
POWER CORD
GREEN
REAR
PLATE ' S
FIRE BRICK
THERMOSTAT
MOTOR
FIRE BLANKET ' S
REAR MOTOR COVER
ACCESS FROM
REAR OF STOVE
POWER CORD
Advertisement
Table of Contents
