Section Iv: Residential Freestanding Installation; Out Side Air Installation - BuckMaster Model 21 Features Preparations Installation Operation Maintenance Safety

RESIDENTIAL FREESTANDING INSTALLATION
TOOLS FOR INSTALLATION
Drop cloth, 3/32" Metal drill bit, 5/16" magnetic socket chuck adapter, 5/16" wrench (box or socket) or adjustable
wrench, Jigsaw with masonry, metal and wood blades
WARNING: DO NOT INSTALL IN A SLEEPING ROOM
PREPARING THE STOVE FOR INSTALLATION
1. Remove the protective plastic wrapping from unit, inspect unit for any obvious physical damage.
2. Plug power cord into a 115V AC outlet to test motor and fan when optional motor is being used. Do not run cord
under unit or in high traffic areas.
3. Check primary air draft control to ensure that it slides freely.(See Figure 5).
4. Remove any items from within firebox. Spread a dropcloth on floor behind heater. Next, tilt heater so that back is
on drop cloth.
5. ( Leg Kit ): If legs are to be used, obtain four legs, attach legs to holes in bottom of unit with bolts and washers
supplied with the leg kit. (See Figure 5).
6. ( Pedestal Kit ): If pedestal kit is being used an outside air is required, see Out Side Air Installation below. Open
freestanding kit and obtain stand. Place stand against bottom of heater (angle side to heater). Center stand front to
back and also center stand left and right. Mark screw locations on bottom of stove through outer holes of stand
mounting angles. Set stand aside and drill four 7/32" holes in heater bottom. Before attaching heater to stand,
take a large flat screwdriver or pliers and remove the 2" x 2" knockout on bottom of unit.
(See Figure 5A). Then mount stand to bottom of heater with screws provided. (See Figure 5A).
7. Obtain four (4) 3/16" self-tapping screws and secure stand to heater.
8. Reposition heater to the upright position.
PRIMARY AIR
DRAFT CONTROL
THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR MUST BE MAINTAINED. (MOVE
OPENING AND/OR REPOSITION HEATER LOCATION IFNECESSARY).
1. Select an installation location that gives the best airflow from the front of heater to remainder of home.
2. Place protective floor pad in position. For minim floor protection (See Page 14).
SECTION IV
HOLES FOR MOUNTING PEDESTAL
Figure 5A
Figure 5

Out Side Air Installation

CAUTION
Page 13
2" x 2"
KNOCKOUT
PEDESTAL