Out Side Air Installation - BuckMaster 18 Manual

Non-catalytic unit features preparations installation operation maintenance safety

Hide thumbs Also See for 18:

Instructions manual (7 pages)

Table Of Contents

Table of Contents

THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR MUST BE MAINTAINED.

(MOVE OPENING AND/OR REPOSITION HEATER LOCATION IF NECESSARY).

1. Select an installation location that will give best airflow from front of heater to remainder of home.

2. Place protective floor pad in position. For minimum floor protection (See Page 26).

3. Place unit on pad making sure minimum clearance specifications are met. For minimum clearance to

combustibles (See Page 27).

4. Lightly mark with a pencil location of pedestal on protective pad.

5. Next, remove four (4) screws holding heater to stand. Position heater out of way of installation area.

6. Check that pedestal stand is still aligned with marks on protective pad, now mark outside air opening

in bottom of pedestal stand on to pad.

7. Mark center line of outside air opening. Set stand aside for now.

8. Cut a 4 1/4" diameter hole in pad and continue through floor.

THE STRUCTURAL INTEGRITY OF THE HOME FLOOR MUST BE MAINTAINED. (MOVE

OPENING AND/OR REPOSITION HEATER LOCATION IF NECESSARY).

9. Now, reposition pedestal stand and set on pad being sure to line stand up with reference marks.

10. Using an electric drill and 3/8" masonry bit, drill four (4) holes in protective pad using holes

bottom of pedestal stand as a guide. Be careful to drill only through pad and not into floor.

Change bit to a 1/4" metal bit and drill through floor.

11. Using four (4) 3/8" x 1-1/2" lag bolts provided, secure pedestal stand and pad to floor of home.

IF A THICK FLOOR PROTECTOR IS USED, YOU MAY HAVE

12. Obtain outside air duct from the box in pedestal kit marked FA P21B.

13. Slip duct down through 4-1/4" hole until face of outside air duct with screen

wire, contacts bottom of pedestal.

14. Secure outside air duct to inside bottom of pedestal using the four (4) #10x1 screws

provided. (See Figure 13).

15. Set heater back onto stand and resecure using screws.

Figure 13

(4) 3/8" x 1-1/2"

FLOOR PROTECTOR PAD

UNDER SIDE OF MOBILE HOME FLOOR