Table of Contents
Advertisement
QQ
3 7 63 1515 0
SPECIFICATIONS
AMPLIFIER SECTION
Continuous average power output (FTC)
All channels:
Continuous power output (DIN) 135 W at 6 Ohm
Maximum power output (EIAJ)
Dynamic power output (stereo) 2 x 250 W at 3 Ohm
Total harmonic distortion:
IM distortion:
Damping factor:
Input sensitivity and impedance
PHONO:
LINE (CD, TAPE, DVD,
VIDEO 1-5):
MULTICHANNEL INPUT
(FRONT L/C/R, SURROUND
L/R, SURROUND BACK L/R): 200 mV, 50 kohm
(SUBWOOFER):
COAXIAL 1, 2, 3 (DIGITAL):
DVD, VIDEO 1, 2, 3, 4, 5:
COMPONENT VIDEO 1, 2:
TE
L 13942296513
Output level and impedance
Rec out (TAPE, VIDEO 1, 2):
Pre out:
VIDEO (VIDEO 1, 2, MONITOR
OUT, ZONE 2 OUT):
COMPONENT VIDEO OUT:
Phono overload:
Frequency response:
RIAA deviation:
Tone Control
Bass:
Treble:
Signal-to-noise ratio (Direct)
Phono:
Line:
Muting:
www
.
http://www.xiaoyu163.com
100 W per channel min. RMS at 8
Ohm , 2 channels driven from 20Hz to
20 kHz with no more than 0.08%
total harmonic distortion.
130 W min. RMS at 6Ohm , 2 channels
driven from 1 kHz with no more
t h a n
0 . 1 %
t o t a l
distortion.
160 W at 6 Ohm
2 x 210 W at 4 Ohm
2 x 130 W at 8 Ohm
0.08% at rated power
0.08% at 1 W output
0.08% at rated power
0.08% at 1 W output
60 at 8 Ohm
2.5 mV, 50 kohm
200 mV, 50 kohm
36 mV, 50 kohm
0.5 Vp-p, 75 Ohm
1 Vp-p, 75 Ohm
1 Vp-p, 75 Ohm (Y)
0.28 Vp-p, 75 Ohm (C)
1 Vp-p, 75 Ohm (Y)
0.7 Vp-p, 75 Ohm (P
, P
B
R
200 mV, 470 Ohm
1 V, 470 Ohm
1 Vp-p, 75 Ohm
1 Vp-p, 75 Ohm (Y)
0.28 p-p, 75 Ohm (C)
1 Vp-p, 75 Ohm (Y)
0.7 Vp-p, 75 Ohm (P
, P
B
R
120 mV RMS at 1 kHz, 0.5% T.H.D.
5 Hz to 100 kHz : +1/ -3 dB
(CD in Direct mode)
20 Hz to 20 kHz : ±0.8 dB
±10 dB at 50 Hz
±10 dB at 20,000 Hz
80 dB (IHF A, 5 mV input)
110 dB (IHF A, 0.5 V input)
Due to setup menu
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
TUNER SECTION
FM
Tuning range
USA & Canadian models:
Australian models:
Usable sensitivity
Mono:
h a r m o n i c
Stereo:
50 dB quieting sensitivity
Mono:
Stereo:
Capture ratio:
Image rejection ratio
USA & Canadian models:
Australian models:
IF rejection ratio:
Signal-to-noise ratio
Mono:
Stereo:
Alternate channel attenuation:
Selectivity:
AM suppression ratio:
Total harmonic distortion
Mono:
Stereo:
Frequency response:
Stereo separation:
AM
Tuning range
USA & Canadian models:
Q Q
)
3
Autralian models
6 7
1 3
Usable sensitivity:
Image rejection ratio:
IF rejection ratio:
Signal-to-noise ratio:
Total harmonic distortion:
GENERAL
Power supply
USA & Canadian models:
Australian models:
)
Power consumption
USA & Canadian models:
Australian models:
Dimensions (W x H x D):
Weight:
REMOTE CONTROLLER
Transmitter:
Signal range:
Power supply:
Specifications and features are subject to change without notice.
.
9 4
2 8
87.5–108.0 MHz (100-kHz steps)
87.50 –108.00 MHz (50-kHz steps)
11.2 dBf, 1.0 µV (75 Ohm IHF)
0.9 µV (75 Ohm DIN)
17.2 dBf, 2.0 µV (75 Ohm IHF)
23 µV (75 Ohm DIN)
17.2 dBf, 2.0 µV (75 Ohm )
37.2 dBf, 20 µV (75 Ohm )
2.0 dB
40 dB
85 dB
90 dB
76 dB
70 dB
55 dB
50 dB (DIN)
50 dB
0.2%
0.3%
30 Hz–15 kHz, ±1.0 dB
45 dB at 1 kHz
30 dB at 100 Hz–10 kHz
530 to 1,710 kHz (10-kHz steps)
1 5
0 5
522 to 1,611 kHz (9-kHz steps)
8
2 9
9 4
30 µV
40 dB
40 dB
40 dB
0.7%
AC 120 V, 60 Hz
AC 230 –240 V, 50 Hz
8.1 A
655 W
435 x 175 x 460 mm
17-1/8"x 6-7/8"x 18-1/18"
38.4 lbs. (17.4 kg)
Infrared
Approx. 16 ft., 5 meters
Two " AA " batteries (1.5 V x 2)
m
co
DTR-7.3
9 9
2 8
9 9
Advertisement
Table of Contents
