Mitsubishi Electric MJ-E14EG-S1-IT Service Manual page 27

(7) Removing and replacing the blower net and the blower motor
Remove the board holder from the board
assembly.
→ (See (6) Removing and replacing the
power supply board)
Remove the net.
Disconnect the P7 connector from the
power supply board.
Remove the casing set screws (2), and lift
up the casing to remove it.
Remove the blower fan stop nut, and
remove the blower fan.
Remove the blower motor holding plate set
screws (4), and remove the blower motor.
→ (Removing and replacing the
blower motor)
<Precautions for Assembly>
The motor lead wires must pass through
the casing catch.
(8) Removing and replacing the power plug
Remove the board holder from the power
supply board assembly. → (See (6)
Removing and replacing the power supply
board)
Disconnect connector P1 from the power
supply board.
Remove the earth wire set screw(1), and
remove the power cord earth wire.
Remove the power cord from the main
unit clamper, and remove from the bottom
groove. → (Removing and replacing the
power plug)
<Precautions for Assembly>
When installing the earth wires, give them
some slack.
Casing set screws (2)
Blower motor holding plate set screws(2)
Blower motor
holding plate
Blower motor holding plate
set screws(2)
Remove connector P1
Power supply board
Earth wire set screw (1)
Remove connector P7
Power supply board
Net
Nut
Casing
Blower motor
Note: The motor lead wires must
pass through the casing catch.
Power plug
Blower fan
27