Disassembly And Reassembly Hints - Mitsubishi Electric MJ-E14EG-S1-IT Service Manual

14. Disassembly and Reassembly Hints

[Precautions for Assembly]
• Firmly connect the lead wire connectors. Firmly tighten the screw connectors in particular.
• If the binding band holding the lead wires is cut, it must be replaced with a new binding band.
• Hold the lead wires that were removed in place with a clamper, etc. and do the wiring.
(1) Removing the water tank
Pull out the water tank from the side
bottom of the unit. → (Removing the
water tank)
(2) Removing the fi lter cover and rear casing assembly
Remove the water tank. → (See (1)
Removing the water tank)
Push the tab on the fi lter cover up,
pull it forwards, and remove the fi lter
cover. → (Removing the fi lter cover)
Remove the rear casing set screws
(6) and special screws(2). Detach
the catch(1).
Remove the rear casing.
<Precautions for Assembly>
When assembling the rear
casing, be careful not to pull out
the lead wires around
the control board.
24
Special
screws (2)
Catch (1)
Water tank
Tab
Rear casing Pull it straight out because it is
set screws (6) on rails
Main
unit
Filter
cover
Rear
casing