La Crosse Technology WS-9037U-IT Manual page 36

Note:
•
Transmission problems will arise if the setting for additional sensors is not followed as
described above. Should transmission problems occur, it is necessary to remove the
batteries from all units and follow the set-up from step 1.
•
If the signal reception is not successful on the first frequency (915MHz) for 45
seconds, the frequency is changed to 920MHz and the learning is tried for another 45
seconds. If still not successful the reception is tried for 45 seconds on 910MHz. This
will also be done for re-synchronization.
10. Once the remote temperature has been received and displayed on the Temperature
Station, the WWVB time code reception is automatically started. This takes typically
between 3-5 minutes in good conditions.
IMPORTANT:
•
Transmission problems will arise if the setting for additional sensors is not followed as
described above. Should transmission problems occur, it is necessary to remove the
batteries from all units and follow the set-up from step 1.
•
If after 10 minutes, the Atomic auto-set time (WWVB time) has not been received,
press the SET key to manually enter a time initially.
•
Daily WWVB reception is attempted at full hour between 12:00 am to 6:00 am. If the
9