Jøtul FS 165 - I 400 FL Installation And Operating Instructions Manual page 46

ENGLISH
Fig. 12
1. Position the burn chamber on the stand. Make sure that the
burn chamber is positioned stably.
Attach the External air connection (cat. no. 341279) if this
2.
is selected.
Fig. 13
Replace the heat shield (Fig. 13 A).
1.
Use the accompanying threaded pins and nuts (Fig. 13 B) as a
2.
replacement for M8x16mm which was removed (see Fig. 5 A).
3. Remove the 3 tapping screws and turn the upper heat shield
upside down (Fig. 13 C).
46
B
A
C
Fig. 14
Mount the first rear plate to bracket 6 that is placed under
1.
the first layer of soap stone.
Mount bracket 3 from the inside through the back plate (Fig.
2.
14 A). Use a hammer and knock it gently into the soap stone.
3. Place the side stones of the second layer between the corner
stones and the rear plate. Use bracket 3 to hold it in place
(Fig. 14 B).
4. Make sure everything is level.
Fig. 15
A
Attach the decorative frame (Fig. 15 A) to the burn chamber
1.
using the threaded pins and nuts mounted in figure 13 B.
2. The position of the frame can be adjusted with the nuts
(Fig. 15 B).
B
A
B