Table of Contents
Advertisement
Q.
I noticed a redness of the skin after using the device.
Is this a problem?
A.
A slight redness of the skin after a session with the
AbCommand™ iX2™ fitness belt is normal. It should
fade quickly. Some redness may also be caused by pressure to
the skin from the stretched belt. You should not be concerned
about this. If the redness is excessive, you may not have used
enough Conductive Gel and/or one or more of the Conductive
Pads may have dried out during a longer session. Try using
more Conductive Gel the next time, replenish it after each
10 minute session and use a lower intensity level.
25
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
LCD Display does
- Batteries not
not light up at all
installed
- Batteries installed
incorrectly
- Batteries are dead
LCD Display lights
- No skin contact
up, but warning
beep is emitted
(high pitched
tone)
- Unit not snapped
on belt correctly
- Microprocessor
hang up
- Batteries are low
LCD Display lights
- Intensity set to
up, but nothing
low level
occurs
- Not enough
Conductive Gel
on belt
- Gel used on the
Conductive Pads is
not water-based
SOLUTION
- Install batteries
- Check polarity "+" sign
- Replace batteries
- Use water-based gel on
Conductive Pads and
place belt directly onto
skin.
- Check that unit is
connected firmly with
all connectors to the belt.
- Check that all Conductive
Pads are connected
firmly to the belt.
- Choose intensity mode
and increase intensity by
pushing the up buttons
for left and right
channels
- Remove batteries for
1 minute for full RESET
- Change batteries
- Choose intensity mode
and increase intensity by
pushing the up buttons
for left and right
channels
- Put more water-based
gel between belt and
skin
- Read label on the gel
that you use. Make
sure you find "water"
or "aqua" in the
ingredient list.
26
Advertisement
Table of Contents
