Acclimatizing; Positioning; Mains Connection; Fuses - Hensel Pro MINI 1200 AS User Manual

1
HENSEL-VISIT International GmbH
Take care for sufficient air supply and make sure that
ventilation slots of power packs and flash heads are kept
free.
Do not operate power packs and flash heads unattended.
Due to the danger of overheating, the modeling light
should never be operated at full power for more than 20
minutes. Then adequate cooling should be provided for.
The modeling light should never be used for lighting up
the studio but only as assistance when focusing or
determining the light guiding and shadow details of the
flash.

Acclimatizing

When moving a power pack from one climatic zone to the
next, the appliance should stand in the room, in which it
will be operated, for some time before starting it up. This
prevents internal shortcuts, which might occur by con-
densing water.

Positioning

Pro Mini power packs can be operated standing face up.

Mains connection

The type label can be found on the bottom of the
appliance.
Multivoltage version
The power pack adjusts itself for different main voltages.
Flash power packs must only be connected to mains
outlets with ground connection.
Insert the plug of the provided power cable into the mains
connector 1 and then connect the cable to the mains
outlet.

Fuses

Outlets, in the building
Slow charging:
Normal charging:
User manual // Pro Mini 1200 AS Power Pack
Ue = 230 V
10 A
16 A
Ue = 115 V
16 A
20 A
35