Panel Pro Mini Generator; Switching On And Off; Synchronization - Hensel Pro MINI 1200 AS User Manual

User manual // Pro Mini 1200 AS Power Pack
2:
ON / OFF
14:
SYNC
13
9:
SLAVE
15:
TEST
38
Operation Pro Mini Power Pack

Switching ON and OFF

By pressing main switch 2 the power pack will be turned
on and off, respectively.
Synchronization (flash triggering)
Synchronization by cable
The Pro Mini 1200 Power Pack can be connected via the
synchronization socket 14 to the camera using the pro-
vided synchronization cable.
The synchronization circuit is made up of state-of-the-art
semi-conductor technology and enables secure triggering
of the flash even with older cameras with mechanical
contacts.
Due to the many different electronical circuits in cameras
for controlling synchronization, we cannot take any
liability for possible damage to cameras triggering
flashes. Please contact the camera manufacturer before
using an unusual camera.
Synchronization by slave
The built-in slave 13 can trigger the power pack.
Triggering is then effected by an "incoming" flash, which
was emitted by another flashlight. This mode of operation
is switched on using push-button 9 until the LED indicator
lights up. The slave is an impulse photo cell. It can only
operate when the triggering flash has a higher f-stop than
the ambient light. Please be aware that the ambient light
that strikes the slave may never be too strong.
If this cannot be avoided, please switch the slave off and
release the flash by cable or radio signal.
Synchronization with Strobe Wizard transmitter
See information on pp. 40-41
Test flash
By pressing the TEST button 15 test flashes can be
released.
HENSEL-VISIT International GmbH