Internet Fax Features; Pre-Installation Information/Features - Panasonic Workio DP-8020 Operating Instructions Manual

Before setting up your Panasonic machine on your network, please read this entire section to be familiar with its functions.
Your machine is able to perform the following when connected to a 10Base-T/100Base-TX Ethernet LAN (Local Area
Network):
• Send paper-based information as an Internet Email.
• Send Internet fax message (Direct Internet Fax XMT).
• Receive and print an Internet Email automatically.
• Forward received G3 Fax message(s) or Email automatically to the preprogrammed Email Address or regular G3 Fax
machine (see "Fax Forward" on page 122).
• Route received G3 Fax message(s) automatically to the sender-specified Email Address or G3 Fax machine using ITU-
T SUB-Address (see "Inbound Routing" on page 120).
• Route received G3 Fax message(s) automatically to the preprogrammed Email Address or G3 Fax machine using the
sender's fax ID Code (see "Inbound Routing" on page 120).
• Relay an Internet Email to a G3 Fax machine via regular fax transmission (see "Relayed Transmission" on page 124).
• Scan to Email.
To utilize the above functions, your machine needs to be set up properly on your network. Please contact your network
administrator for actual network setup.
Copy the Pre-installation Information form found at the end of this section on page 50, record the MAC Address on the
form, and ask your network administrator to complete the remaining information on the form. The MAC Address of your
machine can be found on the 3rd page of the Fax Parameter List printout.
To print the Fax Parameter List, follow the steps below:
Press
FAX/EMAIL
46

Internet Fax Features

Pre-Installation Information/Features

(If set on other function mode), then press
6 4
FUNCTION SET
.