Panasonic Workio DP-8020 Operating Instructions Manual page 23

2
If set on other
function mode.
5
The document(s) will be stored into memory with a file number
when sending from the ADF (Automatic Document Feeder).
Then starts dialing the Telephone Number or connecting to the
LAN immediately after storing the first page. (See Note 5)
The remaining page(s) continue to store into memory.
• If memory overflow occurs while storing documents, the machine will show "MEMORY FULL"
on the display. In the factory default setting (Fax Parameter No. 82 (QUICK MEMORY XMT)
is set to "Valid"), the machine will transmit the stored documents automatically when
transmitting to one station. If Fax Parameter No. 82 is set to "Invalid" and transmitting to one
station, the machine will change the transmission mode from Memory to Direct XMT
automatically when it detects that memory overflow will occur.
In the "Valid" setting, the machine will show "MEMORY FULL" and prompts you whether to
transmit the successfully stored documents or to cancel the transmission.
Press
seconds, the machine will start transmitting the stored documents.
If memory overflows while storing the 1st page, use Direct Transmission.
• An Information Code will be displayed if the transmission has failed or there was no answer at
the receiving side after the last automatic redial.
The document stored for the transmission will be erased from the memory automatically and
the information code is printed for the transmission on the Communication Journal (COMM.
JOURNAL).
If you need to retain the incomplete documents even after the last redial, change the Fax
Parameter No. 31 (INC. FILE SAVE) to "Valid" in advance. (See page 149)
To retry the incomplete documents, refer to page 110.
NOTE 4. If you are using Pulse dialing and you wish to change to Tone dialing in the middle of dialing,
press
The dialing mode will be changed from Pulse to Tone after dialing the digit "/".
Ex: 9 PAUSE TONE 5551234
5. This feature is called "Quick Memory Transmission". If you wish to store all the document(s)
into memory first before transmitting, change the Fax Parameter No. 82 (QUICK MEMORY
XMT) to "Invalid".
6. You can send the same document(s) to multiple stations by repeating Steps 4a, 4b or 4c, and
then pressing
7. The "QUICK MEMORY TRANSMISSION" feature is disabled if multiple stations are set.
Select the desired
3
Transmission setting.
(See page 11)
"YES" to cancel or press
1
(represented by a "/").
TONE
.
START
4a
4b
4c
When an original is scanned from the Platen
6
Glass, the message "ANOTHER
ORIGINAL?" is shown.
Place another original, then
press
Machine starts sending.
"NO" to transmit. If no action is taken within 10
2
.
START
23