WeP LQ540DX User Manual page 16

Multi-part forms
With the built-in tractor unit, your printer can print continuous multi-part forms
(four parts including the original). You can load the multi-part paper in the
same way as you load continuous paper. The only difference is that the paper
thickness lever is to be adjusted before loading.
NOTE:
Multi-part forms should not be used without adjust the print head gap
position.
Labels
If you need to print labels, choose the type of label that is mounted on a
continuous backing sheet with sprocket holes for use with the tractor. Do not
use single sheet labels on a shiny backing sheet because they almost always slip
a little if fed by friction alone. Load the labels the same way as you load
continuous paper; just adjust the paper thickness lever before loading.
WARNING:
• Never feed labels backward through the printer. Labels can easily come
off the backing and jam the printer. Also, never use the sheet load lever to
eject labels or to feed labels backward to the standby position.
• Since labels are especially sensitive to temperature and humidity, always
use them under normal operating conditions.
Envelopes
You can feed envelopes individually using the single sheet-loading feature.
Adjust the paper thickness lever before loading.
CAUTION:
• Always keep the longer side of the envelope horizontal.
• Envelope printing is only available at normal operating conditions.
• If you use No.6 envelopes, make sure that the left edge guide is aligned with
the arrow on the paper guide.
16