Warning Messages - Yamaha RX-V671 Owner's Manual

1 2 3 4 5 6 7 8 9 10
Automatic speaker setup

Warning messages

Even if any warning message is displayed after the measurement, you can save the measurement results by following on-screen instructions.
However, we recommend you perform YPAO again to use this unit with the optimal speaker settings.
Warning message
Any of the speaker cables may be connected with the
W-1: Out of Phase
reversed polarity (+/-).
Any of the speakers is placed more than 24 m from the
W-2: Over Distance
listening position.
There are a significant volume differences between the
W-3: Level Error
speakers.
Cause
Select "Wiring" in "Result" (p.37) and check the cable connections (+/-) of the speaker indicated with
"Reverse". If the speaker is connected incorrectly, turn off this unit and then reconnect the speaker cable.
Depending on the type of speakers or room environment, this message may appear even if the speakers are
connected correctly.
Select "Distance" in "Result" (p.37) and move the speaker indicated with ">24.0m (>80.0ft)" within 24 m of
the listening position.
Check the use environment and cable connections (+/-) of each speaker, and the volume of the subwoofer.
We recommend using the same speakers or speakers with as similar specifications as possible.
Remedy
39
En