Table of Contents
Advertisement
Troubleshooting chart (continued)
■ MP3/WMA/JPEG files
Symptom
●
Playback does not
start.
●
Some files cannot
playback.
●
Read-in time takes
very long.
■ Remote control
Symptom
●
The remote control
does not operate.
■ Tuner
Symptom
●
The radio makes
unusual noises
continuously.
■ Condensation
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet (CD pickup, etc.) or on the transmitter on
the remote control.
Condensation can cause the unit to malfunction. If this
happens, leave the power on with no disc in the unit until
normal playback is possible (about 1 hour). Wipe off any
condensation on the transmitter with a soft cloth before
operating the unit.
Possible cause
●
Is the disc loaded upside
down?
●
Are the files supported by
the unit?
●
Are the files supported by
the unit?
●
Is it a false MP3 file?
●
Is the JPEG file size more
than 10Mbytes?
●
Is the disc contain too many
folders or files?
●
Is the file size too big?
●
Is the disc distorted or
scratched?
Possible cause
●
Is the AC power lead of the
unit plugged in?
●
Is
the
battery
correct?
●
Are the batteries dead?
●
Is the distance or angle
incorrect?
●
Does the remote control
sensor receive strong light?
Possible cause
●
Is the unit placed near the
TV or computer?
●
Is the FM aerial placed
properly? Move the aerial
away from the AC power
lead if it is located nearby.
■ If problem occurs
When this product is subjected to strong external
interference
electricity, abnormal supply voltage due to lightning, etc.)
or if it is operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1
Set the unit to the stand-by mode and turn the power on
again.
2
If the unit is not restored in the previous operation,
unplug and plug in the unit again, and then turn the
power on.
Note:
If neither operation above restores the unit, clear all the
memory by resetting it.
■ Before transporting the unit
Remove the CD from the unit. Make sure there is no CD in
the disc tray. Then, set the unit to the power stand-by
mode. Carrying the unit with discs left inside can damage
the unit.
■ Clearing all the memory (reset)
polarity
At Tuner function, press and hold MEMORY button for 3
seconds.
●
The unit will go stand-by mode.
●
All memory content will be cleared.
Caution:
●
This operation will erase all data stored in memory
including tuner preset, and CD programme.
●
To do reset in DVD/CD function, please remove any
disc inside.
■ Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on the
disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
●
Do not write on either side of the disc, particularly the
non-label side from which signals are read. Do not
mark this surface.
●
Keep your discs away from direct sunlight, heat, and
excessive moisture.
●
Always hold the CDs by the edges. Fingerprints, dirt, or
water on the CDs can cause noise or mistracking. If a
CD is dirty or does not play properly, clean it with a soft,
dry cloth, wiping straight out from the centre, along the
radius.
33
(mechanical
shock,
excessive
static
Advertisement
Table of Contents
Troubleshooting
