Sending A Fax By Direct Keypad Dialling - Sharp FACSIMILE UX-P410 Operation Manual

Sending a Fax by Automatic Dialling

Sending a fax by Direct Keypad Dialling

You can also enter a full number with the number keys and then press the
START/MEMORY
number when you don't need to speak to the other party before faxing.
1
Load the document.
•
If desired, press
resolution and/or contrast.
2
Enter the number of the receiving machine by pressing the number
keys.
•
If a pause is required between any of the digits to access a special service
or an outside line, press
Several pauses can be entered in a row.
•
If you are on a Flash-type PBX and are dialing out, press
FUNCTION
to insert a pause, and then enter the number of the receiving
machine.
•
If you are on a PBX and must dial a number to dial out, enter the number,
FUNCTION
press
machine.
3
Check the display. If the number of the receiving machine shown is
correct, press
•
If the number is not correct, press
at a time, and then re-enter the correct digit(s).
36
key to begin dialling. You can use this method to dial a full
RESOLUTION/
RECEPTION MODE
FUNCTION
to insert a pause, and then enter the number of the receiving
START/MEMORY
.
to set the
. The pause will appear as a hyphen.
STOP
to backspace and clear one digit
READY TO SEND
, press
R