Sony MEX-BT5000 Service Manual page 15

1
5
c
1
1 8 2
m m
1
A
Precautions
• Choose the installation location carefully so that the
unit will not interfere with normal driving operations.
• Avoid installing the unit in areas subject to dust, dirt,
excessive vibration, or high temperature, such as in
direct sunlight or near heater ducts.
• Use only the supplied mounting hardware for a safe
and secure installation.
Mounting angle adjustment
Adjust the mounting angle to less than 45°.
Removing the protection collar
and the bracket
Before installing the unit, remove the protection
collar 5 and the bracket 1 from the unit.
1
Remove the protection collar 5.
Pinch both edges of the protection collar 5, then
pull it out.
2
Remove the bracket 1.
1 Insert both release keys 4 together between
the unit and the bracket 1 until they click.
2 Pull down the bracket 1, then pull up the unit
to separate.
Mounting example
Installation in the dashboard
Notes
• Bend these claws outward for a tight fi t, if necessary (5- 2 ) .
• Make sure that the 4 catches on the protection collar 5 are
properly engaged in the slots of the unit (5- 3 ) .
How to detach and attach the
front panel
Before installing the unit, detach the front panel.
6-A To detach
Before detaching the front panel, be sure to press (OFF).
Press (OPEN), then slide the front panel to the right
side, and pull out the left side.
2
4
1
2
5 3 m
m
Claws
B
6-B To attach
Place the hole A in the front panel onto the spindle B
on the unit, as illustrated, then push the left side in.
Warning if your carís ignition
has no ACC position
After turning the ignition off, be sure to press
and hold (OFF) on the unit until the display
disappears.
Otherwise, the display does not turn off and this causes
battery drain.
RESET button
When the installation and connections are completed, be
sure to press the RESET button with a ballpoint pen, etc.,
after detaching the front panel.
Power connection diagram
Auxiliary power connector may vary depending on the
car. Check your carís auxiliary power connector diagram
to make sure the connections match correctly. There are
three basic types (illustrated below). You may need to
switch the positions of the red and yellow leads in the car
stereoís power connecting lead.
After matching the connections and switched power
supply leads correctly, connect the unit to the carís
power supply. If you have any questions and problems
connecting your unit that are not covered in this manual,
please consult the car dealer.
Face the hook inwards.
c
3
Dashboard
1
5
Auxiliary power
connector
Yellow continuous power supply
4
Yellow switched power supply
4
MEX-BT5000
c
Fire wall
6
7
c
Red Red
Yellow Yellow
Red switched power supply
7
Red Red
Yellow Yellow
Red continuous power supply
7
Red Red
Yellow Yellow
the car without ACC position
15