Table of Contents
Advertisement
Powering the PRO6 system
Powering the PRO6 system
The following details the recommended power up and power down procedures for the
PRO6 system.
Note: If you are in any doubt as to how to switch the DL3n1 units on/off, refer to their
operator manuals.
>> To power up the PRO6 system
Important Note:
DO NOT switch on the speaker sub-system until after the start-up of the PRO6
system has been completed.
After all PRO6 system interconnections have been made (refer to Figure 14 "Standard
system configuration" on page 60), start up the PRO6 system:
1
Make sure that all of the PRO6 system equipment is switched off, that is, the
PRO6 Control Centre, speaker sub-system, DL351 Modular I/O unit and DL371
DSP unit.
2
Switch on the PRO6 Control Centre (see "To switch on the PRO6 Control Centre"
on page 62).
3
In the master bay of the PRO6 Control Centre, move all of the monitor and
master channel faders to the minimum position and mute all of the master
channels (see section F in Figure 2 "Main areas of the control surface" on
page 7).
4
Switch on the DL351 Modular I/O unit.
5
Switch on the DL371 DSP unit.
6
After both status indicators at the top of each GUI screen
have changed to green (as shown right), switch on the
speaker sub-system.
7
Switch on the audio source and start playing the audio.
8
On the PRO6 Control Centre, check that the audio inputs are routed to the master
channels. Then, unmute the master channels and gradually increase their faders
while listening to the sound levels from the speakers.
If there is no sound at all coming from the speakers when the faders are at maximum,
move the faders to below the 0dB level and check if the audio is muted somewhere
along the input paths and also check that the individual speakers are switched on. If
there is still no sound from the speakers, see "No audio" on page 67.
>> To power down the PRO6 system
Important Note:
BEFORE switching off any of the PRO6 system components, don't forget to
mute the audio from the speakers and switch off the speaker sub-system.
1
Mute the audio from the speakers and switch off the speaker sub-system.
2
Switch off the DL351 Modular I/O unit.
3
Switch off the DL371 DSP unit.
4
Switch off the PRO6 Control Centre (see "To switch off the PRO6 Control Centre"
on page 62).
PRO6 Control Centre
Quick Reference Guide
61
Advertisement
Table of Contents
