Isofix Child Seats - CITROËN C3 PICASSO Handbook

Child safety
"ISoFIX" mountings
Your vehicle is approved to the latest ISOFIX
regulations.
The seats represented below, are fitted with
regulation ISoFIX mountings:
There are 3 rings for each seat:
2 rings A, located between the backrest
-
and the seat cushion, identified by a label,
102
a ring B, located in the roof, with the TOP
-
TETHER logo, for fixing the top tether belt.
The TOP TETHER is used to secure the
upper strap of child seats that have one. This
arrangement limits the forward tipping of the
child seat in the event of a front impact.
This ISoFIX mounting system provides reliable,
safe and fast fitting of the child seat in your
vehicle.
ISOFIX child seats are fitted with two latches
which are secured easily on these rings A.
Some also have a top tether belt which can be
attached to ring B.
To secure the child seat to the TOP TETHER:
- raise the head restraint,
- pass the child seat upper strap between
the rods of the head restraint,
- fix the hook on the upper strap to the
ring B,
- tighten the upper strap.
If a child is not installed in a vehicle
correctly, the child's protection in the
event of an accident will be compromised.
Follow strictly the advice given in the
installation instructions provided with
the child seat.
Refer to the table for the possibilities for fitting
ISoFIX child seats in your vehicle.
The rear seats must be in the fully back
position to install ISoFIX seats.