Colored Paper; Preprinted Paper - Kyocera FS-1010 Operation Manual

Special Paper
Table 4.4 lists the specifications for adhesive label paper.
Table 4.4 Adhesive Label Specifications
Item
Weight of top sheet
Composite weight
Thickness of top sheet
Composite thickness
Moisture content
Envelopes
The printer can print on envelopes using paper with a basis weight of 60 to
2
79 g/m (16 to 21 lb/ream). Envelopes must be manually fed.
An envelope is a more complex object than a single sheet of paper. For this
reason, it may not be possible to obtain consistent printing quality over the
entire envelope surface.
Many envelopes have a diagonal grain orientation. (See
page 4-5.) This orientation is more likely to wrinkle and crease on its way
through the printer. Before purchasing envelopes for use with the printer,
test a sample to verify the envelope's suitability.
Do not use envelopes that have an encapsulated liquid adhesive.
Avoid long printing runs consisting of envelopes only. Extensive envelope
printing can cause premature printer wear.
To avoid jamming due to curled envelopes, do not leave more than
approximately 10 printed envelopes stacked in the paper trays during
multiple envelope printing.

Colored Paper

Colored paper should satisfy the same conditions as white bond paper,
listed in Table 4.1 on page 4-2. In addition, the pigments used in the paper
must be able to withstand the heat of fusing during the printing process
(up to 200°C or 392°F).

Preprinted Paper

Preprinted paper should have a bond paper base. The preprinted ink must
be able to withstand the heat of fusing during the printing process, and
must not be affected by silicone oil.
Do not use paper with any kind of surface treatment, such as the type of
paper commonly used for calendars.
Specification
2
44 to 74 g/m (12 to 20 lb/ream)
104 to 151 g/m
0.086 to 0.107 mm (3.9 to 4.2 mils)
0.115 to 0.145 mm (4.5 to 5.7 mils)
4 to 6% (composite)
4-9
2
(28 to 40 lb/ream)
Paper Grain
on