Inspection And Installation Before Use - Taiji Ti-2 Operating Instructions Manual

Inspection and Installation Before Use

1. Take the product out of the package,
and check the manual for operating
instructions, and accessories.
2. Install the product at a place which
meets the following conditions.
• Horizontal and stable
• Well-ventilated
• Free from heat effects. Avoid exposure to
direct sunlight, near a gas heater, gas range, or
other heat source. (Keep the product at least
50 cm away from the above heat sources.)
• Free from high humidity and exposure to water
3. Attaching the fixing angles
Be sure to attach the fixing angles to the machine
to prevent it from falling.
How to attach the fixing angles
q Hold the fixing angle in such a way that its
holes are in line with the corresponding holes
on the side of the machine.
w Tighten an accessory screw in the bottom hole.
e Repeat the same on the other side.
4. Grounding
Be sure to ground the machine to prevent electric
shock.
Ask your dealer for details. Before connecting or
disconnecting the grounding wire, be sure to pull
out the power plug from the electrical outlet.
Outlet with a grounding terminal
Check that the grounding wire (green) is fixed
securely to the machine before connecting its end
to the grounding terminal of the electric outlet.
q
w
-6-
Outlet without a grounding terminal
Ask your dealer for the required Class 3 ground-
ing. (In this case, grounding must be done by a
qualified electrician.)
Do not connect the grounding wire to any of the
following. (Prohibited by law)
• Gas pipe: Danger of explosion or ignition
• Telephone wire or lightning arrester: Danger of
lightning
• Water pipe: PVC pipe may be used some-
where in your water pipeline.
5. Cleaning inside
The product is already cleaned inside before ship-
ment. When you are going to use it for the first
time, however, clean it according to the following
procedures.
q Push the power plug into an electrical outlet,
and flip the power switch up to switch the
machine on.
w Check that the sake drain cock and the nozzle
are in the closed position, then pour hot water
(about 70°C) into the sake tank. Exercise care
in pouring hot water.
e Discharge about half of the hot water from the
sake drain cock. Push the nozzle in to dis-
charge the remaining hot water. When there is
no longer hot water to be discharged, pull the
nozzle toward yourself and switch power off.