Other Operations; Switching Between Digital And Analog Audio (Input Mode); Naming Inputs - Sony HT-DDW3000 Operating Instructions Manual

\

Other Operations

Switching between
digital and analog audio
(INPUT MODE)
When you connect components to both digital
and analog audio input jacks on the receiver,
you can fix the audio input mode to either of
them, or switch from one to the other,
depending on the type of material you intend
to watch.
1
Turn INPUT SELECTOR on the
receiver to select the input.
You can also use the input buttons on the
remote.
2
Press INPUT MODE repeatedly
on the receiver to select the
audio input mode.
The selected audio input mode appears on
the display.
Audio input modes
x AUTO
Gives priority to digital audio signals when
there are both digital and analog connections.
If there are no digital audio signals, analog
audio signals are selected.
x ANALOG
Specifies the analog audio signals input to the
AUDIO IN (L/R) jacks.
Note
Some audio input modes may not be set up
depending on the input.

Naming inputs

You can enter a name of up to 8 characters for
inputs and display it on the receiver's display.
This is convenient for labeling the jacks with
the names of the connected components.
1
Press the input button to select
the input you want to create an
index name for.
You can also use INPUT SELECTOR on
the receiver.
2
Press AMP MENU.
"1-LEVEL" appears on the display.
3
Press V/v repeatedly to select
"5-AUDIO".
4
Press or b to enter the
menu.
5
Press V/v repeatedly to select
"NAME IN".
6
or b to enter the
Press
parameter.
The cursor flashes and you can select a
character. Follow the procedure given in
"To create an index name" (page 46).
47 GB