Table of Contents
Advertisement
Other Operations
Controlling the TV with the
Supplied Remote
By adjusting the remote signal, you can control
your TV with the supplied remote.
TV
TV CH +/–
with the TV
button
ENTER
Number
buttons
With cover opened.
Note
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number may reset itself to the default (SONY)
setting. Reset the appropriate code number.
Controlling TVs with the
remote
Press and hold TV [/1 while entering your
TV's manufacturer's code (see the table)
using the number buttons. Then release TV
[/1.
If you set successfully the manufacturer's code,
the remote transmits the on/off signal of the TV.
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the one
that works with your TV.
Manufacturer
SONY
DAEWOO
FISHER
GOLDSTAR
HITACHI
JVC
LOEWE
MAGNAVOX
MITSUBISHI/MGA 022
TV ?/1
PANASONIC
PIONEER
TV/VIDEO
RCA/PROSCAN
SAMSUNG
TV VOL +/–
with the TV
SANYO
button
SHARP
TOSHIBA
ZENITH
To control the TV
You can control the TV by using following
buttons.
By pressing
TV [/1
TV/VIDEO*
TV VOL +/–*
TV CH +/–*
Number buttons* Select the TV channel.
* To use these buttons, set the remote to the TV mode
by pressing the TV button. To cancel the TV mode,
press the TV button again.
You can select the TV channels by using the
number buttons.
To select the TV channels, press the number
buttons, then ENTER.
Note
• Depending on the TV, you may not be able to control
your TV or to use some of the buttons above.
• The TV mode turns off when you do not operate the
remote for 10 seconds.
Code number
001 (default)
002, 004, 005, 006
009
020
014, 015
018
027, 028
034
049, 050
029
012, 032, 033
036
010
039, 040
046
016, 017
You can
Turn the TV on or off.
Switch the TV's input source
between the TV and other input
sources.
Adjust the TV volume.
Select the TV channel.
69
GB
Advertisement
Table of Contents
