Quick Start - Minelab GPZ7000 Instruction Manual

Quick Start

Quick Start
Start detecting quickly with these six
easy steps:
When the detector is turned on for the first time, or following
a Reset All, you will be prompted to set the Language, the
Weight and Length Units, and the Time Zone before the
Detect page will be displayed.
1
Turn On
Press the Power button on the control
panel. After the start up screens, the Detect
page will be displayed.
2
Select Quick Start
The first function on the Detect page is
Quick Start. It is highlighted by default.
Press Select to start the Quick Start Guide
sequence.
3
Reset Settings
Select 'Reset Audio and Detection Settings' when
prompted to select an option.
4
Noise Cancel
Carry out Noise Cancel noise reduction by following the
Guide sequence
5
Quick‑Trak
Carry out Quick-Trak ground balancing by following the
instructions displayed on-screen. It is very important to
keep the coil as close as possible to the ground, and
to sweep repeatedly over the same spot. The audio will
quickly become quieter.
6
Start Detecting
Take the Field Guide included with your GPZ 7000 when
you go detecting for reference.
Read this instruction manual for more information on
advanced operation of the detector.
14
If you experience any difficulties
using the detector after changing
any settings, run the Quick Start
Guide sequence again to easily
reset the detector and return to
detecting.