Ga 10 Guide Arm - Minelab GPZ7000 Instruction Manual

Assembly
To listen to audio via the WM 12, insert the headphone
plug into the WM 12 headphone socket.
The WM 12 must be wirelessly linked with the detector
using a wireless connection process to hear audio. See
page 11 for WM 12 connection instructions.
NOTE
The WM 12 can be used without
headphones, as it has an in-built speaker.
For more information on the WM 12 see
page 11.
GA 10 Guide Arm
The GA 10 Guide Arm is an optional attachment that
helps to reduce fatigue during long detecting sessions,
and increases swing accuracy. The GA 10 attaches to
the mid shaft and features a Flex-link and strap for easy
adjustment. A C-clip is included with the GA 10 so that it
can be clipped to the detector when not in use.
Assemble GA 10
1.
Attach the shaft strap to the Flex-link by looping the
end of the strap through the narrowest slot. Pull until
the strap is captured by the Flex-link.
2.
Attach the Flex-link to the GA 10 shaft. Align the
holes in the shaft with the key on the Flex-link. Push
the Flex-link onto the end of the shaft until it clicks
into place.
3.
Attach the C-clip, with the hook pointing towards the
GA 10 handle. Apply firm pressure to snap the clip
onto the shaft.
Attach GA 10 to your detector
The GA 10 can be assembled to the detector for left or
right handed use. These steps illustrate assembly for a
right handed user. For left handed use, perform the same
steps with the GA 10 on the left side of the detector.
1.
Place the Flex-link approximately half way down the
detector's mid shaft.
2.
Wrap the strap around the shaft and loop the end of
the strap through the slot on the Flex-link. Pull the
strap tight until the Flex-link hook is through the first
slot on the strap.
7