Unpacking And Installation; Unpacking; Parts Included; Installation Procedure - Sharp AR-EB7 Service Manual

[3] UNPACKING AND INSTALLATION

1. Unpacking

<Before installation>
For improvement of workability, any part of the description in this
manual may be modified without prior notice. In this case, refer to
the service manual.

2. Parts included

IMC2 PWB (with frame)
screw (golden) M3 x 6: 4pcs.
Installation manual: 1 volume

3. Installation procedure

Turn the main switch of the copier to the "OFF" position and then
remove the power plug of the copier from the power supply outlet.
1) Remove the rear cover.
Remove the screw, push the portion indicated by the arrow to
unlock the rear cover, and slide the cover to the right to remove it.
Pawl for
locking
2) Cut out the cut-out portion of the rear cover.
Cut out the cut-out portion with nippers or the like.
At this time, be careful about the orientation of the nippers so that
the cut plane of the rear cover is flat.
3) Attach the IMC2 PWB.
Fit the two pawls on the rear surface of the IMC2 PWB frame to the
mounting portions of the copier and secure the PWB with the four
supplied golden screws M3 x 6.
Screws (golden)
M3 x 6
Pawl
AR-EB7 UNPACKING AND INSTALLATION
– 4 –
Rear cover
Cut-out portion
Rear cover
Take care not to get
the cable caught.
IMC2 PWB
Screws (golden)
M3 x 6
Screw
Pawl