Finishing; Minimum Mantel Clearances; Log Placement - Napoleon GVF40P Installation And Operating Instructions Manual

20

7.0 FINISHING

7.1

MINIMUM MANTEL CLEARANCES

RISK OF FIRE, MAINTAIN ALL SPECIFIED AIR SPACE CLEARANCES TO COMBUSTIBLES. FAILURE
TO COMPLY WITH THESE INSTRUCTIONS MAY CAUSE A FIRE OR CAUSE THE APPLIANCE TO
OVERHEAT. ENSURE ALL CLEARANCES (I.E. BACK, SIDE, TOP, VENT, HEARTH, MANTEL, FRONT,
WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BE
Combustible mantel clearance can
vary according to the mantel depth.
Use the graph to help evaluate the
clearance needed. The four-sided top
extension piece may be removed if
non-combustible framing is faced with
a non-combustible material.
Dashed lines are suitable mantel
sizes and clearances when a non-
combustible facing is used.
7.2

LOG PLACEMENT

LOGS MUST BE PLACED IN THE EXACT LOCATION IN APPLIANCE. DO NOT CHANGE FROM THE
PROPER LOG POSITIONS, SINCE HEATER MAY NOT FUNCTION PROPERLY AND DELAYED
TM
PHAZER logs and charcoal embers, exclusive to Napoleon® fi replaces, provide a unique and realistic glow-
ing effect that is different in every installation.
7.2.1 Looking at the unit from the valve side, place
the fi bre burner onto the locating pins on the
pan burner as illustrated above. It is important
not to cover any burner ports with the fi bre
burner.
W415-0810 / 06.11.09
ETC.) ARE CLEARLY MAINTAINED.
HEAT RESISTANT TO PREVENT DISCOLOURATION.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
LOCATING SCREWS
LOCATING
PINS
WARNING
!
WARNING
!
IGNITION MAY OCCUR.
7.2.2 Place log #1 diagonally across the textured
burner cover onto the pins. The texture is
designed to cradle the underside of the log.
FIGURE 7.1