Connection To Water Supply - Miele W 6073 Operating Instructions Manual

Notes for the installer
The machine must not be moved without
all the outer panels in place.
The transit fittings should be stored in a safe
place for future use. They must be re-fitted if
the machine is moved again.
Do not install the machine on carpeted
flooring if the carpet pile blocks the venti-
lation gap at the base of the machine.
Levelling
The machine must stand level to ensure
smooth operation.
The adjustable feet can compensate for an
uneven base.
^ Screw the foot or feet out until the machine
stands level.
^ Hold the foot tight using a pipe wrench.
^ Tighten the counternut using a screwdriver
as indicated.
30

Connection to water supply

Connection must be made to the water sup-
ply via a stopcock which conforms with local
and national regulations. This work must be
carried out by a suitably qualified and com-
petent person.
To ensure the machine is correctly con-
nected please observe the installation plan
and the installation instructions supplied with
the machine.
See the installation diagram supplied for in-
structions on connection to the water supply
and for drainage.
The inlet pressure hoses supplied with the
machine must be used for connection to the
water supply.
To ensure the hot water inlet hose (marked
90°C) lasts for many years it is advised not
to use it on a hot water connection supplying
water hotter than 70°C.
If replacing an inlet hose only use a hose
able to withstand a burst pressure of at least
70 bar and a temperature of 90°C. This also
applies to all connection parts.
Miele "Original" spare parts are tested to this
standard.
A water pressure flow rate of at least 1 bar,
maximum 10 bar is essential to ensure the
smooth operation of this machine.
Water taken into the machine must not ex-
ceed a temperature of 70°C.
Connection to cold water only
-See the Installation Plan provided.
M.-Nr. 06 006 810