Auto Clear Function; Auto Drawer Switching Function - Kyocera copier Operation Manual

(14) Sort key & indicator
(Press this key when you want to copy with the Sort mode.
Make sure that the Sort indicator is lit green. See page 5-9.)
(15) Program key & indicator
(Press this key when you want to copy with the Program
function. Make sure that the Program indicator is lit green.
See page 5-10.)
(16) Add Toner indicator
(This indicator lights red when the toner supply has run low.
See page 9-2.)
(17) Memory Overflow indicator
(This indicator lights red if the memory becomes full during
scanning of originals. See page 8-1.)
(18) Upper drawer indicator
(This indicator lights green when the upper drawer is selected
as the source of paper feed and it flashes green when the
drawer has run out of paper.)
(19) Upper drawer misfeed indicator
(This indicator lights red if a paper jam occurs in the upper
drawer.)
(20) Paper Feeder indicator
(This indicator lights green when the optional Paper Feeder is
selected as the source of paper feed and it flashes green when
the drawer has run out of paper.)
(21) Paper Feeder misfeed indicator
(This indicator lights red if a paper jam occurs in the optional
Paper Feeder.)
(22) Multi-bypass tray indicator
(This indicator lights green when the multi-bypass tray is
selected as the source of paper feed and it flashes green when
the tray has run out of paper.)
(23) Multi-bypass tray misfeed indicator
(This indicator lights red if a paper jam occurs in the
multi-bypass tray.)
(24) Document Processor indicator
(This indicator will light red if an original jam occurs.)
Section 2 NAMES OF PARTS
Initial mode
(the state that the copier enters at the end of
warm-up or when the Reset/Power key is pressed)
The upper drawer is selected as the source for paper feed, the
number of copies to be made is set to "1" and "Text & Photo" is
selected as the image quality mode.
* If the optional Paper Feeder is installed on your copier, it is
possible for you to change which drawer will be automatically
selected in the initial mode. (See "Default Drawer" on
page 6-2.)
* It is also possible for you to change which image quality mode
will be automatically selected in the initial mode. (See "Image
Quality Mode" on page 6-1.)

Auto Clear function

A pre-set number of seconds (between 10 and 270) after copying
stops, the Auto Clear function will automatically engage and the
copier will return to the same settings as those after warm up
(initial mode settings).(However, the copy exposure setting will not
change.) Copies can continually be made using the same settings
(copy mode and number of copies) if the next batch of copying is
started before the Auto Clear function engages.
* See "Auto Clear Time" on page 6-4 for information on changing
the amount of time before the Auto Clear function automatically
engages, and "Auto Clear ON/OFF" on page 6-3 for information
on turning the Auto Clear function ON and OFF.

Auto Drawer Switching function

If two drawers contain the same size of paper and the paper in one
drawer runs out during copying, the Auto Drawer Switching
function will switch paper feed from the empty drawer to the other
drawer that still contains paper so that copying can continue
non-stop.
* The optional Paper Feeder is required in order to use the Auto
Drawer Switching function.
* It is possible for you to turn the Auto Drawer Switching function
OFF. (See "Auto Drawer Switching ON/OFF" on page 6-2.)
2-5