Kyocera copier Operation Manual page 28

Section 3 PREPARATIONS
1
Open the multi-bypass tray towards you until you hear it
click into place.
2
Pull out the multi-bypass extension and then flip it open.
3
Adjust the insert guides to fit the width of the paper that is
to be set on the multi-bypass tray.
3-6
4
Slide the paper all the way in, along the insert guides, as
far as it will go.
IMPORTANT!
• Only set paper on the multi-bypass tray when you are
planning to use that tray to feed paper. DO NOT leave
paper on the multi-bypass for long periods of time.
• When you are setting paper on the multi-bypass, make
sure that the side to be copied onto is facing upward.
• When using 8
1/2
or Folio size paper, it is recommended that you load
that paper into the drawer(s) and have paper fed from
there. If you do need to use the multi-bypass tray and
such paper does not feed smoothly, continue to support
the paper by its trailing edge until all of the paper has
been fed into the copier.
" × 14" (Legal), 8 " × 13" (Oficio II)
1/2