Wesmar SS395 Installation & Operation Manual page 6

100. Regardless of range the near gain has more
control over targets from the center of the screen
to half way out. Adjust for best presentation.
FAR P
Far gain adjustment for profile. Gain numbers run
from 0 to 100. Regardless of range the far gain
has more control over targets half way to the end
of the screen range. Profile is frequently used to
profile the bottom. FAR P adjustment is used to
bring bottom markings in strong.
SET UP
Set up provides access to three other selection
screens; SONAR, PROFILE, LOCAL. To acti-
vate one of the three screens first trigger the hand
controller once. The WESMAR 395 screen will
appear. Move the four-way switch up or down to
set up. Push the four way switch left or right to
highlight the selection screen you want to go to.
Trigger the hand controller for the second time to
view the screen.
By triggering the hand controller the third time will
place the cursor back into the sonar display.
COLOR BARS
There are two color bars, one on top of the other.
The top color bar represents the colors and thresh-
old for sonar. The bottom bar represents the colors
and threshold for profile. Adjustments are found in
SONAR and PROFILE.
1.3.2 SONAR
Sonar refers to horizontal scan around the vessel.
This is different from profile where the transducer
scans from side to side beneath the vessel. To
maximize target detection both sonar and profile
each have their own selection screen. Adjustments
can be different from the other. The SS395 will
store the settings and recall them the next time the
system is turned on. However, if there is more than
one application (more then one fishery) a record of
the settings should be kept.
R
ANGE
Same range adjustment under Wesmar 395. For
6