Wesmar SS395 Installation & Operation Manual page 5

moves the thickness mode of operation can
move to follow the target by pushing the four-way
switch to the left or right. Reverse can also be used
to change direction of the vertical scan. To end the
thickness mode pull the trigger twice.
2. Highlight thick. Push the four-way switch to
the left or right. The transducer will stop and start
to scan up and down. Push the four-way switch a
second time to end thickness mode. Note: Entering
thickness mode by using the four-way switch will
disable the ability to change bearing. Bearing can
only be changed when entering thickness by using
the trigger switch.
SECTOR
Select the area to be scanned from full circle; 360
degrees down to 11 degrees.
SPEED
Controls the scanning speed of the sound beam.
Speed 1 is for fine resolution. Speed 4 is for fast up-
date. Faster speeds may lose single fish targets.
ZOOM
In Screens 1, 2 and 3 the cursor can be used as
a magnifier. By activating zoom the target under
the cursor will magnify for a close inspection.
The perimeter line around the cursor indicates the
magnified area.
NEAR S
Near gain adjustment for sonar. Gain numbers run
from 0 to 100. Regardless of range the near gain
has more control over targets from the center of
the screen to half way out. Adjust for best presen-
tation.
FAR S
Far gain adjustment for sonar. Gain numbers run
from 0 to 100. Regardless of range the far gain has
more control over targets from half way to the end
of screen range, or the last half of range selected.
Adjust for best presentation.
NEAR P
Near gain adjustment for profile. Profile gains are
separate from sonar. Gain numbers run from 0 to
5