Wesmar SS395 Installation & Operation Manual page 23

0=Off). Connect the two pin inline connector to
the corresponding two pin connector on the switch
pane.
c. Connect the rectangular connector to the com-
puter control unit.
2. Connect the monitor 15 pin connector to the
corresponding connector on the computer control
unit.
3. Bulkhead Connector #78.10389.0
Connect the cable from the bulkhead con-
nector to the computer control unit. The cable is
10 ft (3 m) long.
4. Hoist power cable #78.10182.0
The DC hoist motor can draw up to 4 amps.
Fused with 3.5 slow blow. Before connecting to
ship DC supply, check the voltage of the hoist mo-
tor. The motor will be 12V or 24V. Connect one
end of the DC hoist power cable to the ships DC
supply in the wheelhouse. Polarity is marked,
white is negative, black is positive. Do not
reverse polarity. Connect the other end of the
three pin connector to the three pin connector
on the switch panel.
5. Hoist Control Cable # 78.03900.0
The hoist cable is 25 ft (7.6 m) long. The
cable connects the switch panel to the hoist motor.
Run this cable along with the interconnect cable
in step #6. Confirm the hoist switch is in the up
position before connecting, rocker switch pushed in
on top. Connect one end of the four pin connector
to the four pin connector coming from the switch
panel. Connect the other end to the DC hoist motor
on the hoist assembly. A second hoist control cable
can be used as an extension if addition length is
needed.
6. Interconnect Cable #78.01062.0
The interconnect cable is 25 ft (7.6 m)
long. Run this cable along with this hoist cable in
step #5. Both connectors at each end are the same.
Connect one end to the computer control unit in
the wheelhouse and the other end to the trasmitter
receiver unit on the hoist assembly.
Switch Panel
DC Power Cable
Computer Control Unit
Bulkhead Connector
23