Wesmar SS395 Installation & Operation Manual page 4

RANGE
Sonar range can be increased or decreased by push-
ing the four-way switch on the hand controller to
the left or right. Range units; meter, fathom, feet
are selected in selection screen Local.
TILT
Transducer can tilt up +4 degrees above the hori-
zontal to –90 degrees straight down. A 0 degree tilt
will center the sound beam horizontally.
CENTER
Move the sector in nine-degree steps around the
screen.
REVERSE
Reverse will change the direction of scan. This
is the recommended method when following fast
moving tagets such as tuna and game fish. There
are two ways to reverse scan.
1. Highlight reverse, push the four-way switch to
the left or right. Each time the four-way switch is
pushed scan will reverse.
2. Highlight reverse, pull the trigger to reverse scan.
Pull the trigger again to highlight reverse then pull
the trigger to reverse. As fast as one can pull the
trigger two times the scan will reverse.
THICK
Thickness will work in sonar screen #1 only. Thick-
ness is scanning up and down through the target
or over the bottom. This is an excellent way to see
if there are more fish under the fish schools that
were scanned in the horizontal or to determine the
vertical size distribution of the school. Thickness
can also be used to profile the bottom out in front
entering uncharted
to measure depth when
waters.
There are two ways to activate thickness.
1. Highlight thick. Wait for the horizontal scan
to pass through the target. Pull the trigger, the
transducer will stop and start to scan up and down
through the target. The vertical display will show
the screen. As the target
in the lower right of
4