Led Displays - RC Logger 88002RC Operating Instructions Manual

Rc logger 88002rc
Table of Contents

Advertisement

12. led dIsPlays

The following LED display options are not safety indicators, but only indicate particular operating statuses.
You will find the LEDs on the control board.
ready to fly
After you have plugged in the flight battery and have not yet started the motors, the green LED lights up
and the red LED is off. Your RC EYE 450 is ready to operate. If this is not the case, there is a disturbance.
Please observe the following operating instructions in this chapter.
starting the rC eye 450
Rev the motors. The red LED now lights up permanently and the green LED flashes. After approx. 2
seconds the green LED also lights up permanently. If this is not the case, there is a disturbance. Please
observe the following operating instructions in this chapter.
Configuration mode
During the configuration of the remote control, the red LED indicates the programme step and the green
LED indicates the channel to be programmed through corresponding flashing with pauses.
rC offset adjustment
After the flight battery is connected, the red and green LEDs flash quickly and indicate the alignment of the
transmitter and electronic system of the RC EYE 450. After successful alignment has taken place, the red
LED goes off and the green LED is permanently lit.
adjustment of the neutral position
If an adjustment to the neutral position is carried out, the green LED flashes quickly. The red LED is off.
The following led display options are safety indicators. The causes for the these must be explored
and resolved.
faulty radio link before take-off
You want to take off and the engines are still off. The red and the green LEDs flash slowly at the same time
and indicate a faulty radio link.
Possible causes: Receiver crystal has fallen out of the base, receiver crystal is faulty, receiver antenna
has broken off. Transmitter antenna not pulled out, second transmitter with the same transmitter channel
switched on/ batteries from transmitter empty. Check the possible causes and restart once more.
Should there be permanent radio interference during flight, the RC EYE 450 will start an emergency landing
and the LEDs will also indicate a faulty radio link here through simultaneous flashing.
27

Advertisement

Table of Contents
loading

Table of Contents