RC Logger 88002RC Operating Instructions Manual page 21

During the respective configuration step, the green LED shows the channel as long as the
lever is still operated!
However, only the red LED is important for the progress indicator!
During the programming process, please ensure that you only move the required lever,
otherwise the setting will not be recognised!
Programming of "elevator"
1. Move the elevator lever to full scale for elevating
upwards and hold it there for at least one second.
2. The RC EYE 450 thus recognises the elevator
channel and memorises this.
3. Move the elevator lever back to neutral position,
continue to leave the throttle on zero.
4. As confirmation, the RC EYE 450's red LED flashes
in a cycle of 4s (4x short flashes, then a pause etc.)
Programming of "aileron"
1. Move the aileron lever to full scale left for aileron left
and hold it there for at least one second.
2. The RC EYE 450 thus recognises the aileron channel
and memorises this.
3. Move the aileron lever back to neutral position,
continue to leave the throttle on zero.
4. As confirmation, the RC EYE 450's red LED goes off
and the green LED is lit permanently. This is the end
of the training process.
5. Disconnect the battery from the RC EYE 450 and
remove jumper "R2".
6. Other possibly connected jumpers may be left
plugged in. This is the end of the programming
process for the channels.
21