Kärcher NT 361 Eco Instruction page 8

English
Manual mode
Wet suction
♦ The surface filter is never to be
removed during suction.
♦ The paper filter bag and
membrane filter must be removed
whenever wet dirt is sucked up.
♦ The machine is not switched off
when the container is full with non-
conductive liquids (e.g. drilling
emulsion, oils und greases
♦ The filling level must be checked
constantly and the container must
be emptied in good time.
Fitting rubber lips
Note:
The structured side of the rubber lips
must show outwards.
NT 361 Eco / NT 361 Eco TE / NT 561 Eco / NT 561 Eco TE
Remove the paper filter bag
Remove the membrane filter
Insert power plug
Switch on the machine and start
using it
Note:
♦ Power Filter Clean is activated
automatically (hammering noise)
when sucking up water from a full
container.
♦ Clean and dry the surface filter,
electrodes, and container when
finished wet-vacuuming.
Automatic operation
(only NT 561/361 Eco TE)
Plug in the electric tool mains plug
on the suction machine.(3)
Switch on the machine (1)
The standby lamp is lit (2)
Note:
♦ The vacuum cleaner is
automatically switched on and off
with the electric tool.
♦ The vacuum cleaner has a starting
delay of approx. 0,5 s and an after
running time of max. 15 s.
♦ Electric tools of 100-2200 W
can be connected.
Match the junction box to the electric
tool connector.
♦ Remove the pipe bend from the
suction hose
♦ Fit the junction box to the suction
hose
8