Connection Diagram - Lincoln Electric Power Wave S350 Operator's Manual

A-5
CONNECTION DIAGRAMS
GTAW (TIG) WELDING
A user interface is required for adjusting the TIG weld-
ing settings. A Power Feed wire feeder can be used as
the user interface (Figure A.2), or a S-series user inter-
face (K2828-1) can be installed into the power source
(Figure A.3). Refer to the connection diagrams based
on the user interface that is being used. For either set-
up the K2825-1 solenoid kit is recommended for con-
trolling the gas. Alternate configurations are possible
depending on the wire feeder that is being used. Refer
to the wire feederʼs manual for alternative configura-
tions.
REGULATOR
FLOWMETER
GAS HOSE
PF10-M
WIRE FEEDER
REGULATOR
FLOWMETER
GAS HOSE
INSTALLATION
FIGURE A.2
TIG WITH POWER FEED USER INTERFACE
GAS SOLENOID KIT
(INSIDE MACHINE)
K2825-1
FIGURE A.3
TIG WITH S-SERIES USER INTERFACE
GAS SOLENOID KIT
(INSIDE MACHINE)
K2825-1
POWER WAVE
SMAW (STICK) WELDING
Similar to TIG welding a user interface is required for
adjusting the Stick welding settings. A Power Feed
wire feeder can be used as the user interface, or a
K2828-1 (user interface control panel) can be installed
into the power source (Figure A.4). The connection
diagram shown is based on the S-Series user inter-
face (K2828-1). In this diagram the remote control box
is optional.
GMAW (MIG) WELDING
An arclink compatible wire feeder is recommended for
Mig welding. Refer to Figure A.5 for the connection
details.
ARCLINK CABLE
K1543-[XX]
TO NEGATIVE
(-) STUD
TIG TORCH
K2266-1 KIT
(INCLUDES WORK CLAMP,
ADAPTER, AND REGULATOR)
USER INTERFACE
CONTROL PANEL
K2828-1
TO NEGATIVE
(-) STUD
TIG TORCH
K2266-1 KIT
(INCLUDES WORK CLAMP,
ADAPTER, AND REGULATOR)
S350
®
TO REMOTE CONTROL
RECEPTACLE
FOOT AMPTROL
K87 870
TO POSITIVE
(+) STUD
WORK CLAMP
WORK PIECE
TO REMOTE CONTROL
RECEPTACLE
FOOT AMPTROL
K870
TO POSITIVE
(+) STUD
WORK CLAMP
WORK PIECE
A-5